Leapers Utg Pro 1In 2Pcs Low Profile Picatinny Rings RWU012510

The Leapers UTG Pro 1 inch 2 pc Low Profile P.O.I Picatinny Rings are proudly designed and made in the USA. The Low profile P.O.I rings have a 23mm center height to fit optics with a 1 inch tube and up to a 45mm outer objective. The innovative P.O.I address 3 of the most critical areas in scope rings. They are progressively machined for a precise inner diameter scope interface to achieve a seamless ring-to-scope interaction. The low profile and flush-fitting locking side plate is controlled by dual spring loaded guide rods interfacing with the rail with Torx screw locking to ensure secure and repeatable zero hold. The square shaped integral recoil stop interfaces with a Picatinny slot via complete surface contact to eliminate the possibility of forward and aft movement from recoil vibrations. These rings are machined from 6061-T6 aluminum alloy and 4605 steel with a matte black hard coat anodize and are designed to fit on Mil-spec 1913 Picatinny rail platforms. Each set of 2 rings is equipped with 4 top Torx screws and designed with a 22mm ring width. Low Profile Precision Optics Interface Rings Have a 23mm Center Height to Fit Optics with a 1 inch Tube, and up to a 45mm Outer Objective 2 Piece Ring Set, Each Equipped with 4 Top Torx Screws and Designed with a 22mm Ring Width Designed to Fit on Mil-spec 1913 Picatinny Rail Platforms Machined from 6061-T6 Aluminum Alloy and 4605 Steel with Matte Black Hard Coat Anodize Proudly Designed and Made in USA