Yankee Hill 4400 Srx QD Adapter 9Mm Luger 3/8"-24 Tpi 17-4 Stainless Steel 841812101499

Introducing the YHM sRx Q.D. Adapter! - YHM's new line of sRx products were designed with aesthetics and ease-of-use as the top priorities and that is no different for the YHM sRx Q.D. Adapter (YHM-4400). This Low Profile Q.D. Adapter/Mounting Interface attaches to the industry standard (HUB) 1-3/8 x 24 threads. It features an internal taper seal-in front of the threads-that locks your suppressor on and forms a tight seal to contain gasses while in-use. This means no gasses or debris can build up on the threads. - The sRx Q.D. Adapter must be paired with one of YHM's sRx Muzzle Devices (4405's 4405-MB's and 4401-MB's). - The sRx Q.D. Adapter adds minimal length and weight to the suppressor set up while also allowing you to reap all the benefits of the new YHM sRx System-when used in conjunction with a YHM sRx Muzzle Device. The full YHM sRx (Suppressor Rx) System will be the obvious choice for someone looking for a sleek low-profile suppressor set up-that's also built to withstand rigorous use. This is our prescription for the shooter who cares about the aesthetics of their build as well as its ease-of-use. - Some of the exciting new benefits of the YHM sRx System are as follows: - TIMELESS. (No need to shim/time to barrel) - Small/low profile - No moving parts - Large taper in front of the threads allows for consistent mounting. - Lighter than many Q.D. mounting offerings on the market - Can be permanently attached to firearm barrel needed - The YHM sRx System-just what the doctor ordered! - As always all YHM Products are covered by our Lifetime Manufacturers Warranty - Weight: 1.92 Ounces - Length Added to Suppressor: .200 - Overall Length: .600 - Diameter: 1.563 - Material: 17-4 PH Stainless Steel - Finish: Black Oxide - Designed to Be Used With: The YHM sRx System & any suppressor with 1 3/8 thread! - Caliber(s): 9mm (.390 diameter) or smaller